Just starting out with NRG2/Minibat 2 boards

Hi. I'm brand new to panstamps. I bought the NRG2 kit and some minbat2 boards. I'm a bit at a loss of what to do next. I presume I will:

1) Solder the panstamp board to the minibat board
2) Solder the output of a 18650 battery to the vin / ground on the battery board
3) Wire up an FTDI cable to the RX/TX pins
4) Have fun

Is that right? I'm not expected to populate something on the mini-bat board right? Voltage regulators or some such? I don't need any sensors.

Thanks!